If you think that manual leveling your bed is a real pain each time you start printing (and particularly if you have a removeable magnetic print bed), then adding a BLTouch sensor will likely save you a ton of times and freedom of mind...
I made a mistake when installing the belt, since I haven't measured the provided belt beforehand (I expected to have a lot of margin so I cut the belt for the X motor with 10cm margin and was then short of 3 or 4 cm...
Before mounting your Z lead screws, you should check their planearity. Mine wasn't planar so you need to get a new one if it happens for you. To inspect your screws, please roll them on a flat surface, like yo...
When I received my printer, the current on the motor drivers wasn't set correctly (it was random, I was lucky they didn't burn on first power up).
The TMC2208 drivers (see picture above) must...
An X-Ryl669 website using Grav. Gmail: boite.pour.spam
